iCAx开思网

标题: 请教版主AM_PLOT命令的使用方法 [打印本页]

作者: wenyangang 时间: 2014-11-23 00:20
标题: 请教版主AM_PLOT命令的使用方法
想调用PDF打印机，自动打印二维图，打入命令后出错，不得其解，请版主帮忙指点一下迷津。谢谢了先呀
AM_PLOT terminate actionAM_PLOT plots a drawing, sheet, viewport or specified box to a selected plotter. Syntax +---------------------------------<----------------------------------------+ | | | | | |---->(AM_PLOT)----+---(:OUTPUT)----+-----(

RAWING)-----------------------+------------------+-----> | | | | | +-----(:SHEET)-------------------------+ | | | | | | +-----(:VIEWPORT)----------------------+ | | | | | | +-----(:BOX)---|1st pnt|---|2nd pnt|---+ | | | | | | | +---(:CONTENTS)--+---(:VISIBLE)------+-------------------------------------+-----> | | | | | +---(:ALL)----------+ | | | | | +---(:SCALE)-----+---(:FIT)------+-----------------------------------------+-----> | | | | | +---(:FACTOR)---+ | | | | | +(*)-----(:FACTOR)---|factor|----------------------------------------------+ | | | | +---(

OSITION)----+---(:CENTER)----+--------------------------------------+-----> | | | | | +---(

EFT)------+ | | | | | +(**)---(

APERSIZE)----|frame type|---------------------------------------+-----> | | | | | | +---(:ORIENTATION)---+---(

ORTRAIT)----+----------------------------------+-----> | | | | | +---(

LOT_ANGLE)---|angle|-----------------------------------------+-----> | | | | +----------(:TRANSF_LABEL)---|name|----------------------------------------+-----> | | | | +--(

ATTERN_LENGTH)---(:ALL)--+----------|length|-----------+--(:ACCEPT)--+-----> | | | | | | | | | +--(:OFF)-+-|1...7|--|length|-+ | | | | | | +-------<-----------+ | | | | | +(**)-------(

EVICE)-------|plotter|--------------------------------------+-----> | | | | +(**)-------(

ESTINATION)--|plot dest|------------------------------------+-----> | | | | +(****)-----(:SHOW_DIALOG)---+---(:ON)----+--------------------------------+-----> | | | | | +---(:OFF)---+ | | | +----------------------------------->--------------------------------------+

欢迎光临 iCAx开思网 (https://www.icax.org/)